blackstrat@lemmy.fwgx.uk to DIY@lemmy.worldEnglish · 9 months agoIs this a hammer drill?lemmy.fwgx.ukexternal-linkmessage-square20fedilinkarrow-up11arrow-down10file-text
arrow-up11arrow-down1external-linkIs this a hammer drill?lemmy.fwgx.ukblackstrat@lemmy.fwgx.uk to DIY@lemmy.worldEnglish · 9 months agomessage-square20fedilinkfile-text
The icon is a little different to what I’ve seen on others and I don’t know how to tell otherwise. Thanks!
minus-squareGluWu@lemm.eelinkfedilinkEnglisharrow-up0·9 months agoMasonry bits are carbide tipped and don’t dull, they just break. Heat is not an issue and the bit doesn’t even function by cutting. It’s a downward 45 angle in order to chip as it rotates. There’s no cutting force from the rotation.
minus-squareglimse@lemmy.worldlinkfedilinkEnglisharrow-up0·9 months agoGood masonry bits are carbide-tipped but not all of them. I used those with our sls drill but I stuck to the cheaper ones for anything under 1/2" Perhaps full was the wrong word but the tips do wear out. You wind up with a useless flat stub at the end that won’t push through anything
Masonry bits are carbide tipped and don’t dull, they just break. Heat is not an issue and the bit doesn’t even function by cutting. It’s a downward 45 angle in order to chip as it rotates. There’s no cutting force from the rotation.
Good masonry bits are carbide-tipped but not all of them. I used those with our sls drill but I stuck to the cheaper ones for anything under 1/2"
Perhaps full was the wrong word but the tips do wear out. You wind up with a useless flat stub at the end that won’t push through anything