Entering for Final Fantasy VII Remake Intergrade.

I haven’t done too much gaming recently, I’ve been busy learning how to work my 3D printer and the last few wewks I got a 1988 Suzuki Samurai I’ve been messing with and working on.

Have you tried drying your filament? Wet filament can cause poor bed adhesion.

You wouldn’t suffer any long term effects from the blast at that distance.

As someone who’s slightly on the taller side (5’ 11" 1.8M), I stepped into the shower to make sure the shower head was at least at the top of my head. There were a few that were at about chest level so even with an extended shower head it wouldn’t go over my head and showering would have been always annoying.