I’ve got my mom setup on their PC backup service, no complaints so far (on the Backblaze side that is, she still insists that she doesn’t need continuous backups even though I’ve had to restore multiple times for her).
I switched my backups from Crashplan to B2 as it was significantly cheaper than going to AWS. B2 is more expensive than what I was paying for Crashplan Pro Unlimited (about 8x for the amount of data I have), but I have more peace of mind with it not relying on Crashplan’s terrible Java client.
A reminder that the only good backup is a tested backup.
Typically a Fiber ISP will run Fiber optics only to your DEMARC (or Demarcation) point. This will be usually where your main cable (before any splits) or DSL line used to come in (in the US they’ve been using Orange tubes to indicate this and it will usually run to a panel in some closet or laundry). At the DEMARC they’ll install one of two things: a basic fiber to ethernet converter which will provide you a single ethernet port and a pure tap to the internet, or a Gateway device that will convert the fiber to multiple eithernet with NAT (usually providing other capabilites like TV, Phone, etc).
If you have the latter, you may not get much say in what you can do with your connection, and would be limited to a DMZ mode that is configured on the Gateway. What you put behind the converter or gateway is up to you.