What were you using BEFORE FreeCAD if it has MORE sketch constraints?? Man, I found it so limiting compared to NX. Especially the sketching. And surfacing appeared to be basically nonexistent. Maybe I’m too spoiled with NX, but I dont think I could function for even a day on FreeCAD. It’s worse than SolidWorks (and I hate SolidWorks). I really, really wanted to like it. I even gave it a second chance when 1.0 dropped.
Ah, ok. I’ve been using NX since it was still Unigraphics, so I am admittedly biased. I haven’t tried any of the newer things like Fusion or Sketchup. Might I ask what industry you use FreeCAD for at a professional level? Just curiosity. I’m automotive interiors tooling, so I’m pretty dependent on strong surfacing tools. Lots of A-surface stuff.
Also, how would you model this up in FreeCAD? This took me about 15 minutes in NX, with one sketch and some offset curves. I was making a 3D printed tag for my daughter.
I tried for over two hours in FreeCAD, but only got this far. I could not extrude individual bodies from one sketch, I had to make separate sketches for each shape. Offset curves didn’t appear to be a thing, and I couldn’t find any form of synchronous modeling tools. So, making those raised outlines was a whole other challenge. I ended up having to extrude a sheet taller than the main body, then thicken it. I couldn’t figure out how to select face edges for use in other commands, either. I ended up giving up.
What were you using BEFORE FreeCAD if it has MORE sketch constraints?? Man, I found it so limiting compared to NX. Especially the sketching. And surfacing appeared to be basically nonexistent. Maybe I’m too spoiled with NX, but I dont think I could function for even a day on FreeCAD. It’s worse than SolidWorks (and I hate SolidWorks). I really, really wanted to like it. I even gave it a second chance when 1.0 dropped.
Fusion 360 and before that Google Sketchup
Ah, ok. I’ve been using NX since it was still Unigraphics, so I am admittedly biased. I haven’t tried any of the newer things like Fusion or Sketchup. Might I ask what industry you use FreeCAD for at a professional level? Just curiosity. I’m automotive interiors tooling, so I’m pretty dependent on strong surfacing tools. Lots of A-surface stuff.
Also, how would you model this up in FreeCAD? This took me about 15 minutes in NX, with one sketch and some offset curves. I was making a 3D printed tag for my daughter.
I tried for over two hours in FreeCAD, but only got this far. I could not extrude individual bodies from one sketch, I had to make separate sketches for each shape. Offset curves didn’t appear to be a thing, and I couldn’t find any form of synchronous modeling tools. So, making those raised outlines was a whole other challenge. I ended up having to extrude a sheet taller than the main body, then thicken it. I couldn’t figure out how to select face edges for use in other commands, either. I ended up giving up.